Xerox 5550 - Manual (Page 15)

Operational Safety
Phaser® 5550 Printer
1-7
Operational Guidelines
■ Do not block or cover the slots and openings on the printer. The printer may overheat
without adequate ventilation.
■ For optimum performance, use the printer at elevations below 3,000 m (11,480 ft.).
■ Do not place the printer near a heat source.
■ Do not place the printer in direct sunlight.
■ Do not place the printer in line with the cold air flow from an air conditioning system.
■ Place the printer on a level, solid non-vibrating surface with adequate strength for the
weight of the printer. It should be within 2° of horizontal with all four feet in solid contact
with the surface. The base printer weight without any packaging materials is
approximately 41 kg (90 lb.).
Printing Safety Guidelines
■ Wait 10 to 15 seconds between turning the printer off and on.
■ Keep hands, hair, neckties, etc. away from the exit and feed rollers.
■ Do not remove the paper source tray that you selected in either the printer driver or control
panel.
■ Do not open the doors.
■ Do not move the printer.
Warning: Avoid touching areas inside the printer that are labeled with a warning symbol.
These areas may be very hot and can cause personal injury.
Printer Supplies
■ Use the supplies specifically designed for your printer. The use of unsuitable materials
may cause poor performance and a possible safety hazard.
■ Follow all warnings and instructions marked on, or supplied with, the printer, options and
supplies.