ZyXEL Communications 70 Series User Manual
Page 322
ZyWALL 5/35/70 Series User’s Guide
Chapter 19 VPN Screens
322
Peer ID Type
Select from the following when you set Authentication Key to Pre-shared Key.
•
Select IP to identify the remote IPSec router by its IP address.
•
Select DNS to identify the remote IPSec router by a domain name.
•
Select E-mail to identify the remote IPSec router by an e-mail address.
Select from the following when you set Authentication Key to Certificate.
•
Select IP to identify the remote IPSec router by the IP address in the subject
alternative name field of the certificate it uses for this VPN connection.
•
Select DNS to identify the remote IPSec router by the domain name in the
subject alternative name field of the certificate it uses for this VPN connection.
•
Select E-mail to identify the remote IPSec router by the e-mail address in the
subject alternative name field of the certificate it uses for this VPN connection.
•
Select Subject Name to identify the remote IPSec router by the subject name
of the certificate it uses for this VPN connection.
•
Select Any to have the ZyWALL not check the remote IPSec router's ID.
Content
The configuration of the peer content depends on the peer ID type.
Do the following when you set Authentication Key to Pre-shared Key.
•
For IP, type the IP address of the computer with which you will make the VPN
connection. If you configure this field to 0.0.0.0 or leave it blank, the ZyWALL
will use the address in the Remote Gateway Address field (refer to the
Remote Gateway Address field description).
•
For DNS or E-mail, type a domain name or e-mail address by which to identify
the remote IPSec router. Use up to 31 ASCII characters including spaces,
although trailing spaces are truncated. The domain name or e-mail address is
for identification purposes only and can be any string.
It is recommended that you type an IP address other than 0.0.0.0 or use the DNS
or E-mail ID type in the following situations:
•
When there is a NAT router between the two IPSec routers.
•
When you want the ZyWALL to distinguish between VPN connection requests
that come in from remote IPSec routers with dynamic WAN IP addresses.
Do the following when you set Authentication Key to Certificate.
•
For IP, type the IP address from the subject alternative name field of the
certificate the remote IPSec router will use for this VPN connection. If you
configure this field to 0.0.0.0 or leave it blank, the ZyWALL will use the
address in the Remote Gateway Address field (refer to the Remote
Gateway Address field description).
•
For DNS or E-mail, type the domain name or e-mail address from the subject
alternative name field of the certificate the remote IPSec router will use for this
VPN connection.
•
For Subject Name, type the subject name of the certificate the remote IPSec
router will use for this VPN connection. Use up to255 ASCII characters
including spaces.
•
For Any, the peer Content field is not available.
•
Regardless of how you configure the ID Type and Content fields, two active
SAs cannot have both the local and remote IP address ranges overlap
between rules.
Extended
Authentication
Enable Extended
Authentication
Select this check box to activate extended authentication.
Table 101 VPN Rules (IKE): Gateway Policy: Edit (continued)
LABEL
DESCRIPTION