Yamaha CD Recordable/Rewritable Drive CRW3200 - Manual (Page 25)

Preparing the CRW3200E Drive
17
2
Install the CRW3200E drive carefully into the drive bay
and temporarily fasten the screws by hand.
Be sure that there is enough space to connect the 4-pin internal power
cable, 40-pin IDE cable, and audio cable prior to temporarily fastening the
included four screws to the fixed position.
Do not apply excessive force to the CRW3200E drive.
3
Connect the included 40-pin IDE cable.
Connect the included 40-pin IDE cable to the IDE connector on the
motherboard and the IDE interface connector on the rear panel of the
CRW3200E drive. Be sure that the colored wire is connected to the first
pin of the IDE connector, as shown in the diagram below.
Note
Install the CRW3200E drive
carefully into the drive bay from
the front
Motherboard
IDE connector
40-pin IDE
cable provided
Colored wire
Colored wire
IDE interface
connector