Yamaha 006IPTO-F0 - Manual (Page 62)

62
Chapter 6—Input Channels
DM1000 Version 2—Owner’s Manual
• PAN
This section enables you to adjust the pan setting of the signals routed from the Input Chan-
nels to the Stereo Bus. You can also apply the pan setting to a pair of Bus channels.
If the internal Surround Sound setting is activated, the Surround Pan settings for 3-1, 5.1,
and 6.1 channels are available (see page 125).
• AUX (Aux Send level)
This section enables you to adjust the level of signals routed to Aux Out 1–8. The signals can
be routed to Aux Sends from either the pre-fader or post-fader position.
• INSERT
This section enables you to patch input signals to external devices via the on-board I/O con-
nectors or I/O cards, or insert the internal effect processors.
• METER
This section enables you to switch the metering position of the signal levels that are dis-
played in the Meter page or on the optional MB1000 Meter Bridge. (See page 39 for more
information on selecting the metering position.)
Tip: You can store these channel parameter settings in the Channel library. You can also store
the Gate, Compressor, and EQ parameter settings to the corresponding libraries.