ZyXEL Communications P-660HW-D Series - Manual (Page 309)

P-660HW-D Series User’s Guide
Appendix K Log Descriptions 308
Log Commands
Go to the command interpreter interface.
Configuring What You Want the ZyXEL device to Log
1 Use the sys logs load command to load the log setting buffer that allows you to configure
which logs the ZyXEL device is to record.
2 Use sys logs category to view a list of the log categories.
Figure 178 Displaying Log Categories Example
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.
Figure 179 Displaying Log Parameters Example
4 Use sys logs category followed by a log category and a parameter to decide what to
record.
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to
record only alerts for that category, and 3 to record both logs and alerts for that category.
Not every parameter is available with every category.
5 Use the sys logs save command to store the settings in the ZyXEL device (you must do
this in order to record logs).
Displaying Logs
• Use the sys logs display command to show all of the logs in the ZyXEL device’s log.
• Use the sys logs category display command to show the log settings for all of the log
categories.
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras>?
Valid commands are:
sys exit ether aux
ip ipsec bridge bm
certificates cnm 8021x radius
ras>
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/
1:show debug type]