Xerox VO400E - Manual (Page 11)

VIZIO VO400E User Manual
Version 9/21/2009 11
www.VIZIO.com
VOL CH
MUTE LAST
1 2 3
4 5 6
7 8 9
INPUT
0
_
MENU
GUIDE
TV AV COMP HDMI
VIZIO Remote Control
GUIDE – This button displays program information.
POWER ( ) – Press this button to turn the TV on from the Standby
mode. Press it again to return to the Standby mode.
TV – Press this button to select TV.
AV – Press this button to select AV (either Composite or S-Video) input.
COMP – Press this button to select the Component (YPbPr) input. By
pressing this button repeatedly you will be switching from Component 1 to
Component 2 and vice versa.
HDMI – Press this button to select the HDMI input. By pressing it
repeatedly you will go through the three (HDMI 1, HDMI 2, HDMI 3) inputs
in sequence.
MENU – Use this button for the On-Screen Display (OSD) menu. When it
is used within a menu selection, pressing this key will help you to make the
selection of the feature to be adjusted after it has been highlighted.
!"# $ -These labeled buttons are used to navigate the OSD menu.
When navigating the OSD menu, the arrows control the direction up and
down or left and right. They will also be used as value settings when the
slide bar is shown on the screen and option settings to turn a feature off or
on.
MUTE – This button turns the sound on and off.
LAST – This button recalls the previously viewed channel. If the On-
Screen Display (OSD) menu is being used, this button will allow you to get
back to previous menu screen or out to your program when you press it
repeatedly.
VOL !/" – This button turn the volume up or down.
CH !/" – This button change the channels up or down.
hen
NUMBER BUTTON PAD – Use these buttons to select a channel or enter
sa password.
INPUT – This button allows the user to cycle through the inputs.
Repeatedly pressing of this button will step you through the input sources
in the following sequence: TV, AV, Component 1, Component 2, RGB,
HDMI1, HDMI2, and HDMI3. Once you have stepped through the entire
sequence, you will return to the beginning.
(DASH) – When selecting a digital channel directly use this button for
the separation of main and sub-channels. For example, channel 28-2
would be selected by the button sequence 2 8 ENTER 2.