Xerox DocuMate 272 - Manual (Page 104)

DocuMate 272 Scanner User’s Guide 99
Scanning with the WIA Interface
The Scan using Xerox DocuMate 272 window opens. Use
this window to select scanning options and start the scan
process.
3. Click the button most appropriate for the item you’re scanning.
4. Select a paper size from the Page Size list.
5. Click Preview to preview the image before scanning.
The image is displayed on the right side of the window.
6. Adjust settings of the previewed image as desired:
• Change the button selection for the type of image.
• Adjust the custom settings; refer to the next section, “Fine
Tuning Your Scans”.
• Change the size of the scanned image. To do this, click and
hold the mouse pointer over one of the four sizing-boxes on
the corners of the previewed image. Then drag the box to
increase or decrease the size of the image.
7. Preview the image again. When you are satisfied with the
image, click the Scan button.
NOTE: If you preview when scanning a stack of documents, the
first page of the stack feeds through the ADF for the preview.
After adjusting the scanner settings, replace that page on the
stack so it is scanned with the rest of the pages.