Yeoman YM-E9001FLA - Manual (Page 5)

5
1 2 3 4
Maximum Medium Minimum
Maximum
plus blue & green
flame effects
Turning On the Heat:
2.13 when turning on the heater you must always press the
1kw button. Do not start the fire using the 2kw setting.
2.14 It is NOT advisable to run the heater without the flame
effects switched on.
2.15 Press the 1kW button to turn the fan heater ON. One
red indicator light will be displayed behind the flame effect
screen at the back of the inside of the appliance. The
appliance will blow cold air for approximately 8 seconds
before the heater comes on. On this setting the heater will
operate at half its maximum temperature.
2.16 Press the 2kW button once to turn the fan heater to its
maximum temperature. Two red indicator lights will be
displayed behind the flame effect screen at the back of the
inside of the appliance. After approximately 8 seconds the
heater will operate at its maximum temperature.
2.17 Pressing the 2kw button again will turn the heater OFF
and cold air will be blown for approximately 8 seconds to
cool the appliance.
2.18 Press the 1kW button to return to the lower heat setting.
2.19 Press the On/Off button to turn off ALL settings and
return to Standby. Cold air will be blown for
approximately 8 seconds to cool the appliance.
2.20 The appliance should be turned off via the On/Off switch
when it is not in use.
LOG EFFECT APPLIANCES
2.21 Log effect appliances have a glass fibre fuel bed which
may give off a slight smell when first used. This is
normal and should disappear after a day or two.
THERMAL SAFETY CUTOUT
The appliance is fitted with a thermal safety cutout,
which operates if it overheats. If this happens:
2.22 Unplug the appliance and allow it to cool for 5 - 10
minutes.
2.23 Check the air inlets/outlets for any obstruction and clear
(see Maintenance, Section 3.4).
2.24 Plug in appliance and switch it on. The cutout will re-set
and the appliance should function correctly. If this is not
the case:
2.25 Unplug once more and have the fire checked by a
competent electrician.
USER INSTRUCTIONS
3. MAINTENANCE
3.1 ALwAYS UNPLUG FROM MAINS SUPPLY BEFORE
CLEANING OR UNDERTAKING ANY MAINTENANCE
CLEANING
3.2 Only clean the outer casing when it is cold. Do not use
abrasive cleaners.
3.3 For painted castings, wipe with a damp cloth and buff
with a lint free duster.
CLEANING AIR INLETS
3.4 Ensure the appliance is unplugged.
3.5 Clean the air inlet and outlet grilles regularly with a soft
cloth or the nozzle of a vacuum cleaner.
Dust build-up can inhibit efficient performance of the fan
and lead to the safety cut-out operating.
3.6 Keep the area around the stove clean and free of fluff, dust
or pet hair.
3.7 In particular, build-up of dust etc. can occur around the
heater area under the appliance. Take particular care to
keep this area free from such particles on a regular basis
to prevent build-up.
CLEANING LOG MOULDING
3.8 Ensure the appliance is unplugged and cold before handling
log moulding.
3.9 Follow Section 4, choosing relevant model, to access and
remove log moulding.
3.10 Dust off any build-up with a brush or damp cloth and
replace.