3Com TR - Manual (Page 88)

5-6 C HAPTER 5: C ONFIGURING WITH THE LCD C ONSOLE
Figure 5-2 I/O Module LCD Menus
1 To view the next level, press [Enter].
2 Press the [Down Arrow] until Switch 2000 TR >
Module appears.
3 Press [Enter]. STATUS > Module Type appears.
4 Press [Down Arrow] to scroll down through the I/O
Module menus.
5 Press [Enter] at any one of the following fields to view
the information described below. Press [Down Arrow]
to move through the circular menus.
■ Module Type—One of three module types:
■
FDDI
■
ATM
■
TR-in-FE
■ Module State—The current status of the module
(UP or DOWN).
■ HW Version—The current version of the hardware
PROM code.
■ SW Version—The current version of the software
code. (Not applicable for the TR-in-FE module.)
■
Boot SW Version—The current Boot software
version. (Not applicable for the TR-in-FE module.)
For more information about setting up the modules
refer to the documentation that came with them:
■ SuperStack II Switch 2000 TR ATM OC-3 Module
User Guide (Part Number #99041)
■ SuperStack II Switch 2000 TR FDDI Module User
Guide (Part Number #99048)
■ SuperStack II Switch 2000 TR TR-in-FE Module
User Guide (Part Number #99045)
L
> I/O Module
Switch 2000 TR ENTER ENTER
Module Type
Module State
HW Version
SW Version
Boot SW Ver