3Com 3C840 User Manual
Page 196
E-6
A
PPENDIX
E: C
ONFIGURATION
(N
ON
-S
ETUP
W
IZARD
)
OF
THE
O
FFICE
C
ONNECT
R
EMOTE
840
■
If you want to run RIP, select from the pull-down menu to have the RIP
set to Broadcast, Listen, or Broadcast & Listen, and if one of these
is chosen, set the RIP option to RIPV1 or RIPV2.
■
Ensure that Enable IP is checked (enabled).
2 Press the Next button to proceed to the IP Advanced Modify screen. This
screen contains the following fields:
3 Check the Enable PAT button to use Port Address Translation (refer to
the Configuration Planning Table in Chapter 1 of the OfficeConnect
Remote 840 SDSL Router Install Guide to determine if PAT is to be
enabled).
You cannot use an unnumbered Local IP WAN Address and have PAT
enabled.
840ug.book Page 6 Friday, July 7, 2000 2:23 PM