Service procedures (continued) – 3M HEADSET C1060 User Manual
Page 14
Model C1060 Headset Intercom System
Replacement Parts and Service
©3M 2005 November
14
Service Procedures (continued)
Checking out Headset Operation
Tools Required:
Functioning Wireless Intercom System with at
least one additional model C1060 Headset.
Procedure:
NOTE
Check headset operation before replacing
the case screws. It is a good idea to
simply snap the case together without the
screws until the headset is completely
checked out.
1. Make sure a fully charged battery is installed
in the headset being tested.
2. Turn on the headset and cycle through all of
the operating modes described in Headset
Intercom System Model C1060 Operating
Instructions. These Operating instructions are
available by ordering 3M Stock Number
70-0710-3648-0
3. Replace three case screws, ear cup and pad.