Check your connections – 2Wire HOME PORTAL 100S User Manual
Page 18
14
during setup, but you will need to install the driver. See Appendix A for detailed installation
instructions.
If you are NOT using a 2Wire wireless adapter, you will need to manually configure your adapter of
choice to communicate with the HomePortal BEFORE installing the HomePortal software. See
Appendix B for detailed configuration instructions.
IMPORTANT: Don’t forget to reboot your cable or DSL modem after new connections are made and make
sure that your modem is powered on before proceeding.
Check your connections
With your computer completely started and your wireless card properly configured, verify the
POWER
and
HOME NETWORK
indicator lights on the front of the HomePortal are green. If they are not, see “Diagnosing
connection problems” on page 22. The
BROADBAND
LINK
indicator light will not turn green until the
HomePortal software has been installed and an Internet connection has been established.
Continue to Step 3 “Install the HomePortal Software” on page 15.