3M MicroTouch M170 - Manual (Page 21)

Chapter 2 Setting Up Your M170 FPD Monitor 21
4. Plug the AC/DC power supply into the M170 FPD. Be sure to use the power supply included
with the monitor.
WARNING
To avoid the risk of electric shock which could result in serious injury or death:
• This device must be operated with the original power supply, part number: HJC,
HASU05F.
CAUTION
To avoid the risk of electric shock which may result in minor or moderate injury:
• The socket-outlet should be installed near the equipment and should be easily accessible.
• Use a power cable that is properly grounded. Always use the appropriate AC cord
certified for the individual country. Some examples are listed below:
USA UL
Switzerland SEV
Canada CSA
Britain BASE/BS
Germany VDE
Japan
Electric Appliance Control Act
5. Connect the power cable to the AC/DC supply. Connect the other end to the appropriate AC
outlet.
Figure 12. Connecting the M170 Cables to your Computer
65-2223
You should be sure all cable connections are secure -- tighten all cable screws. Shaking
and vibration may dislodge cables that are improperly connected.
Route all wiring and cabling away from heat sources and sharp metal edges to avoid
damage. Also, keep the touch screen cable away from sources of electromagnetic and
radio frequency interference.
WARNING
To avoid the risk of electric shock which could result in serious injury or death:
• Do not use a damaged power supply.
• Do not use a power cord that is frayed or otherwise damaged.
3M Touch Systems Proprietary Information