Jotul I570 - Manual (Page 37)

37
ENGLISH
Fig. 11
4. Secure the flue pipe in the insert’s smoke outlet using gasket
rope.
NB: It is important that the joints are completely sealed. Air
leakage may cause malfunction.
3.8 Checking the functions
Check the control handles once the insert is in place. These should
move easily and work in a satisfactory manner.
Fig. 12
Air vent (fig. 12 - A)
Left position = closed
Right position = open
NB! Before use, open the door and remove the screw (fig. 12 C).
Ignition vent (fig. 12 - B)
Pulled out
= open
Pushed in = closed
Fig. 9
14. Unscrew the upper heat shield at the rear (fig. 9 A). Turn it
upside down and screw it firmly in position using the same
screws it was fastened with before.
Fig. 10
Log retainer
Mount the log retainer onto the knobs (fig. 10 A) on the rear of
the front frame.
3.7 Assembly/installation
Installation to the chimney
1. Test-mount the insert first without making a hole in the
chimney. See fig. 1 for distances to firewall.
2. The insert is to be installed with a Ø200 mm flue pipe of
approved thickness.
3. Place the insert into its final position.