Festool SRM 45 E-LHS 225 PLANEX - Manual (Page 19)

19
Problem Possible causes Remedy
Filter element clog-
ging. Extreme air humidity Clean the fi lter element regularly:
Option 1: Set the suction power control to the
maximum setting. Cover the nozzle, suction
hose or intake opening on the extractor with
the surface of your hand for 10 seconds until
the automatic cleaning cycle starts.
To clean the second fi lter half: switch off the
machine, switch on again and repeat the pro-
cedure.
Option 2: Clean the fi lter element mechanically
(extracting,).
Option 3: Check the fi lter element for damage
and clogging. Insert a new fi lter element regu-
larly.
Using special repair compounds,
e.g. extremely fi ne, soft fi ller that
generates large quantities of dust. Clean the fi lter element regularly (see above).
Replace the fi lter element regularly.
Machining materials that are not
yet dry Read the technical data sheets and manufac-
turer recommendations.
Using the extractor in wet and dry
mode (mixed mode) Before using the extractor in wet mode, clean
the fi lter element thoroughly after completing
extraction and allow the fi lter element to dry
completely.
If other problems other than those listed occur, please contact your Festool service workshop or your
local specialist dealer.