Festool OF 1400 EBQ - Manual (Page 17)

17
- Secure the copying ring (8.1) to the router base
by inserting both tenons (8.2) into the recesses
(8.3).
- To loosen the copying ring, press both buttons
(1.16) inwards simultaneously.
b) Copying device
The angle arm WA-OF (10.2) and copier scanning
set KT-OF, consisting of roller holder (10.6) and
three copying rollers (10.7), are required for the
copying device.
- Screw the angle arm at the desired height in the
platen’s threaded bore (10.1) with the rotating
knob (10.3).
- Fit a copying roller in the roller holder and bolt
this to the angle arm with the rotating knob
(10.5). Make sure that the copying roller and
cutter have the same diameter!
- Turn the adjusting wheel (10.4) to adjust the dis-
tance between the copying roller and cutter axis.
7 Accessories
For your own safety, use only original
Festool accessories and spare parts.
The accessory and tool order number can be found
in the Festool catalogue or on the Internet under
„www.festool.com“.
8 Maintenance and care
Always remove the power supply plug
from the socket before carrying out any
work on the machine.
All maintenance and repair work which
requires the motor casing to be opened
may only be carried out by an authorised
service centre.
Customer service and repair. Only
through manufacturer or service work-
shops: Please fi nd the nearest address
at: www.festool.com/Service
EKAT
1
2 3 5
4
Use only original Festool spare parts!
Order No. at: www.festool.com/Service
The cool air openings in the motor casing must
always be kept clean and unobstructed to ensure
air circulation.
The tool is fi tted with special motor brushes with
an automatic cut-out. When the brushes become
worn the power supply is shut off automatically
and the tool comes to a standstill.
To alter the position of the clamping lever (see
Fig. 11):
- Release the screw.
- Remove the clamping lever and tighten the
hexagon screw.
- Insert the clamping lever again in the desired
position and lock it with the screw.
9 Environment
Do not throw the power tool in your household
waste! Dispose of machines, accessories and
packaging at an environmentally-responsible
recycling centre. Observe the valid national regu-
lations.
EU only: European Directive 2002/96/EC stipulate
that used electric power tools must be collected
separately and disposed of at an environmentally
responsible recycling centre.
Information on REACh:
www.festool.com/reach