Festool CTL MIDI - Manual (Page 12)

12
CTL MINI/MIDI GB
"MAN" switch position
Appliance socket [1-2] is connected to the power, the
mobile dust extractor starts.
"Auto" switch position
Appliance socket [1-2] is connected to the power, the
mobile dust extractor starts when the connected tool
is switched on.
 Insert the plug into an earthed socket.
Pull the plug from the socket when the ma-
chine is not in use and prior to maintenance
and cleaning work.
6.2 Connecting electric power tools
 Connect the electric power tool to the appliance
socket [1-2].
6.3 Connecting the suction hose [1A]
 Connect the suction hose to the angle adapter [1-
6]
on the extraction opening [1-5].
7 Settings
7.1 Adjusting the suction power
 Use the rotary knob [1-1].
7.2 Applying the brake [1B]
 Raise the front of the dust extractor slightly.
 Push down the brake [1-13] until it engages into
position.
 Actuate the lever [1-12] to release.
7.3 Temperature cut-out
A temperature cut-out switches the mobile dust ex-
tractor off when it reaches a critical temperature to
prevent overheating.
 Switch off the mobile dust extractor, allow to cool
for about 5 minutes then switch on again.
 Not possible to switch on: contact Festool service
workshop.
7.4 SYSDOC
A Systainer can be secured to the storage area [1-7]
using the T-LOC latch [1-8]. Systainers without a T-
LOC can be secured using four SysDoc latches [1-3] .
8 Working
8.1 Extracting dry materials
When extracting dust that exceeds the per-
mitted limit values, only extract from a single
machine (electric or air tool).
Observe the following when extracting dust gener-
ated by operating electric power tools:
Ensure there is adequate ventilation! Observe re-
gional regulations!
Limit values: exhaust air max. 50% of the clear air
volume
Formula: room volume V
R
x air renewal rate L
W
8.2 Extracting wet materials/liquids
Remove the filter bag!
Recommendation: use a special wet filter.
The dust extractor stops automatically when the
maximum level is reached.
After wet extraction, allow the main filter to dry!
8.3 After finishing work
 Switch off the mobile dust extractor and pull out
the mains plug.
 Wind up the mains power cable.
 Empty the dirt trap.
 Place the suction hose [2-1] and mains power ca-
ble [2-2] in the top section. Insert the mains cable
through the recess [2-3] .
 Vacuum and wipe off the inside and outside of the
mobile dust extractor.
 Place the mobile dust extractor in a dry room in-
accessible to unauthorised users.
WARNING
Risk of injury
 Observe the maximum appliance socket con-
nected load (see chapter "Technical data")
 Switch off the electric power tool.
CAUTION
Hazardous dust
Damage to the respiratory passage
 Always use a filter bag!
CAUTION
Escaping foam and fluids
 Switch off and empty the machine immediately.