Festool PDC 18 - Manual (Page 12)

12
PDC 18/4 GB
– Always pull the mains plug out of the socket when the charger is not in use.
– Only for AS/NZS: The tool shall always be supplied via residual current device with a
rated residual current of 30 mA or less.
1.3 Emission levels
Levels determined in accordance with EN 60745 are
typically:
Vibration emission value a
h
(vector sum for three
directions) and uncertainty K measured in accor-
dance with EN 60745:
The specified emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
2 Symbols
3 Technical data
* Speed specifications with fully charged battery
pack.
** The maximum speed is reduced in the lower
torque stages.
Drilling
Sound pressure level L
PA
= 73 dB(A)
Noise level L
WA
= 84 dB(A)
Uncertainty K = 3 dB
Impact drilling
Sound pressure level L
PA
= 104 dB(A)
Noise level L
WA
= 115 dB(A)
Uncertainty K = 3 dB
CAUTION
When working with noise
Damage to hearing
X Always use ear protection.
Drilling in metal a
h
= 5,6 m/s
2
K = 1,5 m/s
2
Fastening a
h
< 2,5 m/s
2
K = 1,5 m/s
2
Impact drilling into con-
crete a
h
= 12,4 m/s
2
K = 3,0 m/s
2
Warning of general danger
Risk of electric shock
Read the Operating Instructions/Notes!
Wear ear protection.
Wear protective gloves.
Wear protective goggles.
Do not throw in the household waste.
Cordless impact driver PDC18/4
Motor voltage 18 V
Idling speed* 1st gear 0 - 400 rpm
2nd gear 0 - 850 rpm
3rd gear 0 - 1850 rpm
4th gear 0 - 3800 rpm
Torque for easy/tough fastening
applications 40/60 Nm
Adjustable torque** 1st gear 0,75 - 12 Nm
2nd gear 0,6 - 7,5 Nm
3rd gear 0,55 - 5 Nm
4th gear 0,5 - 2,7 Nm
Chuck clamping range 1,5 - 13 mm
Drill diameter max. Wood 50 mm
Metal 12 mm
Fastening in pine max. ‡ 8 mm
Tool holder in drill spindle 1/4 ’’
Weight without battery pack with
Centrotec 1,6 kg