Edimax Technology BR-6214K - Manual (Page 15)

14
Click <OK> when you have finished the configuration above. Congratulations! You have completed the configuration for
the Static IP Address connection. You can start using the router now, if you wish to use some of the advance features
supported by this router see chapter 2, 3, 4.
1.3 PPPoE
Select PPPoE if your ISP requires the PPPoE protocol to connect you to the Internet. Your ISP should provide all the
information required in this section.
Parameter Description
Login ID Enter the Login ID provided by your ISP for the PPPoE connection
Password
Enter the Password provided by your ISP for the PPPoE connection
Service Name
This is optional. Enter the Service name should your ISP requires it, otherwise leave it
blank.
AC Name
This is optional. Enter the AC Name should your ISP requires it, otherwise leave it blank.
MTU
This is optional. You can specify the maximum size of your transmission packet to the
Internet. Leave it as it is if you don’t want to set a maximum packet size.
Dial On Demand
If checked, gateway won’t dial this session until received a packet that requested Internet
access. If unchecked, gateway dials this session immediately after system powered up.
Silent Timeout
If specified a non-zero value, gateway disconnects this session after specified idle time.
Auto Reconnect
If checked, gateway redials this session if session previously terminated by ISP.
Auth Type
Select PAP or CHAP for the authentication type requested by your ISP.
Click <OK> when you have finished the configuration above. Congratulations! You have completed the configuration for
the PPPoE connection. You can start using the router now, if you wish to use some of the advance features supported by
this router see chapter 2, 3, 4.