Edimax Technology AR-7267WnB - Manual (Page 6)

5
3. Install ADSL Router
Step 1. Connect the ADSL Line
Use the supplied RJ‐11 telephone cable, connect the router from the ADSL port to your telephone socket
with an ADSL micro filter plugged in.
Step 2. Connect the router to your LAN network
Connect the router to your PC, hub or switch by attached the Ethernet cable to the LAN port of the
router.
Step 3. Connect the Power Adapter to the Router
Connect the power adapter to the power jack on the rear panel of the router and switch on the power.
Step 4. Check the ADSL LED light status
Please check the ADSL LED on the front panel. This light indicates the status of your ADSL broadband
through your telephone line. If the light is on solid, you can continue the setup. However, if the light is
flashing, there is no broadband line being detected. Therefore, please call your Internet Service Provider
(ISP) and inform them about the flashing ADSL light.
Step 5. Firewall settings.
Please turn off all personal firewall before you continue the setup as they might block the
communication of your PC and the router.
Note：You must use the power adapter shipped along with the router, do NOT use any other power
adapter from other sources.