Edimax Technology BR-6258n - Manual (Page 36)

35
2‐4‐5 Using “L2TP” as broadband connection type
1. Select “L2TP” if your ISP is providing you Internet access via L2TP (Layer‐2
Tunneling Protocol).
2. If your ISP is providing you dynamic IP addresses, select “Obtain an IP address
automatically” (refer to 2‐4‐1 for setup details). If your ISP is providing you a static
IP address, select “Use the following IP address” (refer to 2‐4‐2 for setup details).
NOTE: These settings must be configured according to your Internet service. Please
contact your Internet service provider if you are not sure what to select.
3. Configure the “L2TP Settings” section.