Edimax Technology EW-7438RPn - Manual (Page 10)

8
Chapter II: Repeater mode
Repeater mode is your Wi-Fi range extender!
It can extend your wireless signal and coverage and help you to solve
wireless dead zone problem.
This chapter will show you how to quickly install this device by using
quick setup and show you the each detailed setting on web UI page of
repeater mode.
2-1 Repeater mode Quick Installation Guide
For the first time setup and easy installation, you can move this device
close to the Wireless Broadband Router or Access point you wish to
connect, after installation done and wireless connection is built, you can
move this repeater device to the place you wish to use.
Insert this device into power outlet on the wall, and switch wireless
repeater’s power switch to ‘ON’ (1). You should see ‘Power’ LED light
up in few seconds (2). If not, please check if the power outlet you’re
using is working.
You can build wireless connection via ‘Hardware WPS button’ or
‘Software web browser’.
If your broadband router or access point also supports ‘WPS button’, we
recommend you to use WPS button to establish connection, it is the fast
and secure way without computer.
Using WPS button - please go to section 2-1-1
Using Web browser - please go to section 2-1-2
(2)
(1)