Husqvarna 143AE15 - Manual (Page 12)

STARTING AND STOPPING
12 – English
Check before starting
• Check the cutters. Never use cutters that are blunt,
cracked or damaged.
• Check that the machine is in perfect working order.
Check that all nuts and screws are tight.
• Check that the cutting attachment always stops when
the engine is idling.
• Only use the machine for the purpose it was intended
for.
• Make sure that the handle and safety features are in
good working order. Never use a machine that lacks a
part or has been modified outside its specifications.
• All covers must be correctly fitted and undamaged
before you start the machine.
Starting and stopping
Cold engine
Ignition: Set the stop switch to the start position.
Primer bulb: Press the air purge repeatedly until fuel
begins to fill the bulb. The bulb need not be completely
filled.
Choke: Set the choke control in the choke position.
Start throttle:
Set the throttle to the start position by first pressing the
throttle trigger, then pressing the start throttle button (A).
Then release the throttle trigger, followed by the start
!
WARNING! Always move the machine
about 3 metres from the refuelling
position before starting. Place the
machine on a flat surface. Ensure the
cutting attachment cannot come into
contact with any object. Make sure no
unauthorised persons are in the working
area, otherwise there is a risk of serious
personal injury.
H1152440-10,143AE15.fm Page 12 Wednesday, October 28, 2009 11:19 AM