Milwaukee HD 18 AG - Manual (Page 20)

20
Battery acid may leak from damaged batteries under extreme
load or extreme temperatures. In case of contact with battery
acid wash it off immediately with soap and water. In case of eye
contact rinse thoroughly for at least 10 minutes and
immediately seek medical attention.
SPECIFIED CONDITIONS OF USE
The angle grinder may be used for cutting-off, grinding and wire
brushing a wide range of materials, such as metal or stone. If
you have any doubts, please refer to the instructions supplied
by the accessory manufacturer.
Do not use this product in any other way as stated for normal
use.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is in
conformity with the following standards or standardized
documents:
EN 60745-1:2009+A11:2010
IEC60745-1:2006
EN55014-1:2006+A1:2009+A2:2011
EN 60745-2-3:2011
IEC 60745-2-3:2006+A1:2010
EN55014-2:1997+A1:2001+A2:2008
in accordance with the regulations 2011/65/EU (RoHs),
2004/108/EC, 2006/42/EC
Winnenden, 2012-05-27
Rainer Kumpf
Director Product Development
Authorized to compile the technical fi le
BATTERIES
New battery packs reach full loading capacity after 4 - 5
chargings and dischargings. Battery packs which have not
been used for some time should be recharged before use.
Temperatures in excess of 50°C (122°F) reduce the
performance of the battery pack. Avoid extended exposure to
heat or sunshine (risk of overheating).
The contacts of chargers and battery packs must be kept clean.
For an optimum life-time, after use, the battery packs have to
be fully charged.
To obtain the longest possible battery life remove the battery
pack from the charger once it is fully charged.
For battery pack storage longer than 30 days:
Store the battery pack where the temperature is below 27°C
and away from moisture
Store the battery packs in a 30% - 50% charged condition
Every six months of storage, charge the pack as normal.
MAINTENANCE
The ventilation slots of the machine must be kept clear at all
times.
Do not let any metal parts reach the airing slots - danger of
short circuit!
Use only Milwaukee accessories and spare parts. Should
components need to be exchanged which have not been
described, please contact one of our Milwaukee service agents
(see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the ten-digit No. as well as the machine type printed on
the label and order the drawing at your local service agents or
directly at: Milwaukee Electric Tool, Max-Eyth-Straße 10,
D-71364 Winnenden, Germany.
SYMBOLS
Please read the instructions carefully before starting
the machine.
Always wear goggles when using the machine.
Remove the battery pack before starting any work on
the machine.
Accessory - Not included in standard equipment,
available as an accessory.
Do not dispose of electric tools together with
household waste material! In observance of European
Directive 2002/96/EC on waste electrical and
electronic equipment and its implementation in
accordance with national law, electric tools that have
reached the end of their life must be collected
separately and returned to an environmentally
compatible recycling facility.
ENGLISH
289 037 - HD18AG.indd 20 289 037 - HD18AG.indd 20 07.11.2012 14:04:05 07.11.2012 14:04:05