Hama VMPL50 - Manual (Page 3)

ENGLISH
Assembly Instructions for model: VMPL50
Thank you for choosing a VisionMount™ wall mount. This product is designed to mount flat panel televisions weighing up to 130 lb. to a vertical wall.
It allows you to tilt your new television up to 12º without the use of tools.
Safety Warning: If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified contractor
or contact Sanus at 800.359.5520 or www.sanus.com. We can quickly assist you with installation questions and missing or damaged parts. Replace-
ment parts for Sanus products purchased through authorized dealers will be shipped directly to you. Check carefully to make sure there are no missing
or defective parts. Never use defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that
is not explicitly specified by Sanus Systems. Sanus Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly,
or incorrect use. Note: The supplied hardware is not for steel stud walls or old cinder block walls. If you are uncertain about the nature of your wall,
consult an installation contractor.
Required Tools: 3/16 drill bit, 1/2” Masonry Bit for brick concrete or concrete block installations, 1/2” wrench or socket, Phillips screw driver.
Supplied Parts: *Not shown as actual size.
(1) Wall Plate - a* (1) Left Monitor Bracket - b* (1) Right Monitor Bracket - c*
(4) M4 x 12 Bolt - d (4) M5 x 12 Bolt - e (4) M6 x 12 Bolt - f (4) M8 x 16 Bolt - g
(4) M4 x 30 Bolt - h (4) M5 x 30 Bolt - i (4) M6 x 35 Bolt - j (4) M8 x 40 Bolt - k
(4) M4 Lock Washer - l (4) M5 Lock Washer - m (4) M6 Lock Washer - n (4) M8 Lock Washer - o
(4) M4/M5 Spacer - p (4) M6/M8 Spacer - q (8) M4/M5 Washer - r (4) M6/M8 Washer - s
(6) Lag Bolt - t (6) Lag Bolt Washer - u (6) Concrete Anchor - v
(2) Safety Bolt - w (1) Allen Key - x*