Dvd stb, Kd3554, Presentation – Hama KD3552 User Manual

Page 3: Installation

Advertising
background image



HDMI IN 1

HDMI OUT

A

1

5V

KD3554

KD3554

KD3554

}

KD3552/KD3554

KD3552 / KD3554

100-230 V /

50-60 Hz

UK

Europe

DVD

STB

CR2032

EN

PRESENTATION

Your device is an HDMI switch. It allows you to select then transmit digital signals

from devices fitted with the same ports to a flat screen television or a television

fitted with the same connection. This user’s guide is for model KD 3552 (2 HDMI

input ports) and model KD 3554 (4 HDMI input ports).

INSTALLATION

Connect your device by following the instructions on the diagrams at the

beginning of the leaflet (on the cover).

Note: your device is equipped with HDCP which means that you cannot copy protected

recorded material. The device connected to or via the HDMI OUTPUT port can only

be a television, a monitor or a video projector; in this way, the HDMI signal can be

transmitted through the HDMI ports.

To activate the remote, remove the protective strip by pulling it off (model KD 3554 only).

USE

OPERATION

: Press the �/

SELECT

button.The light on the panel comes on

indicating the connection is working.
Your device begins to search for an HDMI signal from one of the HDMI IN ports.

The search will continue until a signal is found. The light shows that the search is

taking place.
Press the �/

SELECT

button to choose another HDMI port. If the other port is

not receiving a signal, the search continues until a signal is found.

If no signal is detected, the light flashes continuously.

Note: model KD 3554 has a remote control which allows you to select the 4 HDMI ports
available on this model.

STOP

: Hold down the �/

SELECT

button for 3 seconds.

Troubleshooting

If you run into difficulty or if the image or sound quality is not satisfactory, try the

recommended solutions.

Problem

The light does not come on

• Make sure that the adaptor is correctly plugged into the wall and that you have

an AC current (check the instructions on the device).

• Make sure that the electricity supply cable is correctly inserted in the electricity

supply port of your device (5V / 1A).

Advertising
This manual is related to the following products: