Hama Sanus Vm300 - Manual (Page 3)

ENGLISH
Assembly Instructions for Model VM300
Thank you for choosing a Sanus Systems Vision Mount wall mount. The VM300 is designed to mount up to 40” LCD flat panel televi-
sions weighing up to 80 lb to a vertical wall. It will allow the television to be just .5” from of the wall.
Safety Warning: If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified
contractor or contact Sanus at 800.359.5520 or www.sanus.com. Check carefully to make sure that there are no missing or defective
parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replace-
ment parts for products purchased through authorized dealers will be shipped directly to you. Never use defective parts. Improper instal-
lation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified by Sanus Systems.
Sanus Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please call
Sanus Systems before returning products to the point of purchase.
Required Tools: Drill, 3/16” drill bit, (1/2” masonry bit for brick, concrete, or concrete block installations), wrench set, philips screw driver
Supplied Parts and Hardware: Some parts not shown as actual size*
(1) Wall Plate - a* (1) Locking Monitor Bracket - b* (1) Monitor Bracket - c*
(3) Lag Bolts - d (3) Lag Bolt Washer - e (3) Concrete Anchor - f
(4) M4 Lock Washer - g (4) M5 Lock Washer - h (4) M6 Lock Washer - i
(4) M4/M5 Washer - j (4) M4/M5 Spacer - k (4) M6 Spacer - l
(4) M4 x 10mm Monitor Bolt - m (4) M5 x 12mm Monitor Bolt - n (4) M6 x 12mm Monitor Bolt - o
(4) M4 x 30mm Monitor Bolt - p (4) M5 x 30mm Monitor Bolt - q (4) M6 x 35mm Monitor Bolt - r