Hama Sanus Vm300 User Manual
Page 5
ENGLISH
k
k
j
j
j
j
l
m
p
n
q
o
r
g
g
h
h
i
i
Step 2: Select the Appropriate Hardware for your television
Always make sure the television is unplugged before threading any bolt into the back panel!
Thread bolts carefully into your television by hand before tightening. If you feel resistance, remove the bolt immediately! If you
are unable to find appropriate hardware for your television, consult a local hardware store or call Sanus Systems.
Locate the threaded inserts on the back of your flat panel television and determine which of the provided Bolts is the correct diameter.
To test each diameter, thread the Bolts carefully into your television by hand until you find the diameter that correctly fits.
Next, determine the correct length of the required Bolt. Televisions with a flat back will require one of the shorter Bolts and no spacer.
Some televisions have a curve, recess, or other obstruction on the back. This may require a longer Bolt along with a Spacer placed be-
tween the television and the Monitor Bracket.
Once you have the correct bolt picked out, you can follow the diagrams below to see what additional hardware you will need to mount
the Monitor Brackets (b,c) to your television. For a television with a flat back, see Step 3 for installation instructions. For all other in-
stances, see Step 4.
Hardware Diagrams: Parts are scaled.
Step 3: Attach Monitor Brackets to a television with a flat back
Make sure the Locking Monitor Bracket (b) is located on the left side as shown in Diagram 3. If your TV requires either an M4 or M5
diameter bolt, thread a M4 x 10mm (m) or M5 x 12mm Bolt (n) through the appropriate Lock Washer (g,h), an M4/M5 washer, the
Monitor Bracket (b,c) and into the TV as shown on the left side of the Detailed View of Diagram 3. If you have determined that your TV
requires an M6 diameter bolt, thread an M6 x 12mm Bolt (o) through a Lock Washer (i), the Monitor Brackets, and into the TV, as shown
on the right side of the Detailed View of Diagram 3 for Assistance. Proceed to tighten the Bolts firmly with a phillips screw driver.
Detailed View
Diagram 3
m,n
g,h
o
j
i
b
c
M4 x 30
M4 x 10
M6 x 35
M6 x 12
M5 x 30
M5 x 12