Shure PSM 900 - Manual (Page 7)

3
Front Panel Controls
① Input Level Control and Display Use the ▼▲ buttons to adjust the
audio so that, for the average input signal level, the top two yellow LEDs
flicker and the lower LEDs are solid. The red clip LED indicates the inputs
are overdriven. Reduce the level at the audio source or change the input
sensitivity of the rack unit from the AUDIO>INPUT menu.
② Status Display and Menu Controls Use the enter and exit buttons
and the menu wheel to access the configuration menu. Push the menu
wheel to move the cursor to the next item. Turn the menu wheel to change
a parameter—the enter button flashes. Press it to save the value. Press
the exit button to cancel changes and return to the previous menu.
③ Synchronization Button Press the sync button while rack unit and
bodypack IR windows are aligned to transfer settings.
④ Headphone Monitoring The volume control adjusts signal output to
the 3.5 mm headphone jack. NOTE: it does not affect rear panel outputs.
⑤ RF switch mutes RF output. For setting up multiple systems or
adjusting settings without transmitting unwanted RF or audio signals.
⑥ Power Button Turns the unit on and off.
Rear Panel Connectors
⑦ Power Connect the transmitter to a power outlet using the supplied
power adapter.
⑧ LOOP OUT Sends a copy of the audio signal going into the transmitter
to another device. See LOOP Applications.
⑨ Audio Inputs Connect to balanced or unbalanced outputs. Use either
connector for mono input. Accepts both 1/4-inch or male XLR connectors.
⑩ Antenna (BNC) Attach supplied antenna. If you are rack mounting, use
a front panel or remote mounting kit from Shure.
level L R menu sync volume power
CLIP
sync
P9T Rack Unit Transmitter
RF Settings
RADIO
G
Sets the group number
CH Sets the channel number
888.888MHz Manual frequency selection
RF POWER Select from 10, 50, or 100 mW (varies by region)
Audio Settings
AUDIO
MODE
Selects monitor mode
STEREO/MX
Transmits both channels
MONO Transmits a mono signal to
bodypack
INPUT Sets nominal input level
LINE +4 dBu
line level
AUX –10dBV aux level
Utilities and Display Settings
UTILITIES
EDIT NAME
Changes the name on the LCD display (this name is
uploaded to the bodypack with sync)
DISPLAY Changes the display format
CONTRAST Changes the display contrast
LOCK PANEL Locks front panel controls. To unlock, press exit,
select OFF, and press enter.
MENU+LEVEL
Locks menu and level
controls.
MENU ONLY Locks only the configuration
menu (menu controls).
MENU+SWITCH Locks all controls except for
the level buttons (including the
RF and power switches).*
ALL Locks all controls (including the
RF and power switches).*
*RF is automatically activated when locked. When
you unlock the unit, RF and power turns off if the
switches are off.
RX SETUP These settings are sent to the bodypack during a
sync (when the sync direction is from the transmit-
ter). The default KEEP parameter will not change the
bodypack settings.
LOCK
Lock bodypack
V LIMIT Volume limiter
LIM VAL Volume limiter value
MODE Stereo (ST) or MixMode (MX)
BAL MX CH. 1 (L) and CH. 2 (R) mix for
MixMode
BAL ST Left (L) and right (R) balance
for stereo mode
HIBOOST high frequency boost
CUSTOM GROUP For creating custom frequency groups
RESET SYSTEM Returns all settings to the factory defaults.
NO
Exit and do not reset system.
YES Reset system settings.