Philips HR1851 - Manual (Page 7)

- Do not remove the pulp container when the appliance is operating.
- Always unplug the appliance after use.
- Noise level: Lc = 86 dB(A)
electromagnetic fields
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
Preparing for use
1 Clean all detachable parts (see chapter ‘Cleaning’).
2 Pull the mains cord out of the cord storage compartment at the back of the appliance.
3 To attach the spout to the juice collector, snap it into position (Fig. 2).
4 Place the juice collector onto the appliance and put the filter in the juice collector. Make sure
the filter is fitted securely onto the driving shaft (Fig. 3).
Always check the filter before use. If you detect any cracks or damage, do not use the appliance
and contact the nearest Philips service centre or take the appliance to your dealer.
5 To attach the pulp container to the appliance, align the latch on the pulp container with the
slot on the motor unit and then push the pulp container home. Hold the lid over the filter
and lower it into position. (Fig. 4)
You can also empty the pulp container while you are preparing juice. Switch off the appliance,
remove the pulp container carefully and empty it.
Note: Reassemble the empty pulp container before you continue juicing.
6 Snap the two clamps onto the lid to lock it into place (‘click’). Slide the pusher into the
feeding tube. (Fig. 5)
Make sure the clamps are locked into position on either side of the lid.
7 Place the juice jug under the spout (Fig. 6).
The juice jug has a removable foam separator to separate the foam from the juice when you
pour the juice into a glass.
using the appliance
Note: Only switch on the appliance after you have assembled all parts properly and you have properly
locked the lid into place with the two clamps.
Do not operate the juicer for more than 40 seconds at a time when you juice heavy loads and
let it cool down afterwards. None of the recipes in this user manual constitute heavy loads.
1 Wash the fruit and/or vegetables and cut them into pieces that fit into the feeding tube.
2 Make sure the spout is attached to the juice collector and the juice jug is placed under the
spout.
3 Turn the control knob to setting 1 (low speed) or 2 (normal speed) to switch on the
appliance. (Fig. 7)
- Speed 1 is especially suitable for soft fruits and vegetables such as watermelons, grapes,
tomatoes, cucumbers and raspberries.
- Speed 2 is suitable for all other kinds of fruits and vegetables.
4 Put the pre-cut pieces in the feeding tube and gently press them down towards the rotating
filter with the pusher.
EnglisH 7