Vitek VT-1763 - Manual (Page 4)

4
ENGLISH
• Before using the unit, closely examine the
power cord and make sure that it is not
damaged. Do not use the unit, if its power
cord is damaged.
• Do not disassemble the unit yourself, if
any malfunction is detected, apply to the
nearest authorized service center.
• Regularly clean the unit; be careful not to
make any scratches on the nebulizer.
• Store the unit out of reach of children.
FOR HOUSEHOLD USAGE ONLY
USING THE HUMIDIFIER
Unpack the unit and remove the packing
materials. Examine the unit for damages. Do
not switch on the unit if there are any dam-
ages in it.
Note:
- if the unit was subjected to negative
temperatures, before switching it on
for the first time, keep it at room tem-
perature for 30 minutes.
- use the unit at temperatures from +5 to
+40°С, and relative humidity less than
80%.
- water temperature should not exceed
+40°С.
Before switching on the unit, make sure that
you home electricity supply corresponds
to the voltage specified on the body of the
unit.
1. Take the handle (10) and remove the wa-
ter tank (11) from the body (16).
2. Turn over the tank (11); unscrew the lid
(14), by turning it counterclockwise. Fill
the water tank (11) with necessary quan-
tity of water and screw the lid on (14) turn-
ing it clockwise.
3. Set the filled tank (11) on the body of the
unit (16). Wait for some time, which is
necessary to fill the operating chamber
with water.
4. Plug in the humidifier, you will hear a
sound signal.
5. Switch on the humidifier, by pressing the
(6) “Power” on/off button, the intensity
indication (22), steam-out level indication
(20, 24) and relative indoor humidity indi-
cation (23) will light up.
Note:
- irrespective of the operation mode the
display lightning (7) switches off in 8
seconds, in order to see the current
mode press any button on the control
panel or remote control.
- minimal possible indication of indoor
relative humidity is 40%.
6. Establish steam-out intensity with steam-
out intensity button (1), that will be showed
on the display (7) by changing indication
(20) and (24).
7. You can set a necessary indoor humidity
level (from 40% to 80%, setting step 5%)
with the help of buttons (2,3), the display
(7) will show indication (21) and blinking
indications of the set humidity (23). In 5
seconds on the display (7) indications
(22, 27) will lighten up and relative indoor
humidity indication (23) will lighten up.
To switch off the automatic indoor humid-
ity maintenance mode, press button (2)
or (3) until symbols « - - » appear on dis-
play (7).
8. To switch on the ionization mode, press
button (4), indication (26) will appear on
the display (7). To switch off the ionization
mode, press button (4) once again, the
indication (26) will disappear.
9. You can set up operation time of the unit
using the (5) Timer button. Press button
(5) to set the required operation time of
the unit from 1 to 12 hours, it will be re-
flected on the display (7) by indications
(25) or digital indication (23).
10.When the water tank becomes empty
(11), on the display (7) indication (28) will
light up, you will hear sound signals and
the humidifier will switch off.
11.After the end of the work switch off the
unit pressing button (6).
4
1763.indd 4 1763.indd 4 10.06.2010 14:12:48 10.06.2010 14:12:48