HONDA 2010 Pilot - Manual (Page 77)

This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. For more information, see
page
.
It comes on as a reminder that you
have turned off the vehicle
stability assist (VSA) system.
It flashes when VSA is active (see
page
).
You will also see a ‘‘CHECK VSA
SYSTEM’’ message on the multi-
information display (see page
).
This indicator has three functions:
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page
). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle flash.
If it comes on and stays on at any
other time, or if it does not come on
when you turn the ignition switch to
the ON (II) position, there is a
problem with the VSA or Hill Start
Assist systems. Take your vehicle to
a dealer to have it checked. Without
VSA, your vehicle still has normal
driving ability, but will not have VSA
traction and stability enhancement.
See page
for more information
on the VSA system.
It comes on along with the VSA
system indicator if there is a
problem with the VSA or Hill Start
Assist systems.
You will also see a ‘‘CHECK VSA
SYSTEM’’ message on the multi-
information display (see page
).
1.
2.
3.
431
95
431
431
95
484
On Touring models
On Touring models
Instrument Panel Indicators
Vehicle Stability Assist
(VSA) System Indicator VSA Activation Indicator Turn Signal and
Hazard Warning
Indicators
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
73
2010 Pilot