HONDA 2012 Accord Sedan - Manual (Page 105)

Push the right side of the switch, HI,
to rapidly heat up the seat. After the
seat reaches a comfortable
temperature, select LO by pushing
the left side of the switch. This will
keep the seat warm.
If the engine is left idling for an
extended period, do not use the
seat heaters even on the LO
setting. It can weaken the battery,
causing hard starting.
Do not use the seat heater in the
HI setting for an extended period,
because it draws large amounts of
current from the battery.
Follow these precautions whenever
you use the seat heaters:
In the LO setting, the heater runs
continuously. It does not cycle with
temperature changes.
In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat’s temperature
drops.
Both front seats are equipped with
seat heaters. Because of the sensors
for the side airbag cutoff system,
there is no heater in the passenger’s
seat-back. The ignition switch must
be in the ON (II) position to use the
heaters.
U.S. SE, EX-L and EX-L V6
Canadian EX-L and EX-L V6
Seat Heaters
102
Driver’s
Seat
Passenger’s
Seat
HEATERS
11/07/09 21:23:07 31TA5640_107
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
2012 Accord Sedan