HONDA 2008 Ridgeline - Manual (Page 272)

Never use a puncture-repairing agent
in a flat tire. If used, you will have to
replace the tire pressure sensor.
Have the flat tire repaired by your
dealer as soon as possible.
For convenience, the recommended
tire sizes and cold tire pressures are
on a label on the driver’s doorjamb.
The following chart shows the
recommended cold tire pressures for
most normal and high-speed driving
conditions.
For additional information about
your tires, see page
.
Every time you check inflation, you
should also examine the tires for
damage, foreign objects, and wear.
You should look for:
Bumps or bulges in the tread or
side of the tire. Replace the tire if
you find either of these conditions.
Cuts, splits, or cracks in the side
of the tire. Replace the tire if you
can see fabric or cord.
Excessive tread wear.
Your tires have wear indicators
molded into the tread. When the
tread wears down, you will see a 1/2
inch (12.7 mm) wide band across the
tread. This shows there is less than
1/16 inch (1.6 mm) of tread left on
the tire.
A tire this worn gives very little
traction on wet roads. You should
replace the tire if you can see three
or more tread wear indicators.
308
Tire Size
Compact Spare
Cold Tire Pressure
Front/Rear:
Tires
Recommended Tire Pressures
Tire Inspection
268
INDICATOR LOCATION MARKS
TREAD WEAR INDICATORS
T165/90R17 105M
P245/65R17 105T 32 psi (220 kPa ,
2.2 kgf/cm )
60 psi (420 kPa ,
4.2 kgf/cm )
2008 Ridgeline
Table Of Contents Main Menu