JVC KS-BTA200 - Manual (Page 34)

32
ENGLISH
Troubleshooting
What appears to be trouble is not always serious. Check the following points before calling a service center.
Symptoms Remedies
Bluetooth device does not detect the unit. • This unit can be connected with one Bluetooth cellular
phone and one Bluetooth audio device at a time.
While connecting a device, this unit cannot be detected
from another device. Disconnect currently connected
device and search again.
The unit does not detect the Bluetooth device. • Check the Bluetooth setting of the device.
• Search from the Bluetooth device. After detecting the
unit, select “Open” on the unit to connect the device.
“Device Unfound/UNFOUND” appears on the display. • Check the Bluetooth setting of the device, then search
again.
The unit does not make pairing with the Bluetooth
device. • Enter the same PIN Code to the unit and target device.
• Select the device name from “Special Device,” then
connect again.
“Connection Error/ERR CNT” appears on the display. • Select “Connect” to connect the device again.
Echo or noise occurs. • Adjust the position of the microphone unit.
“Error/ERROR” appears on the display. • Try the function again.
• (If the message appears again)
The connected device is not equipped with the
function.
“Loading/LOADING” appears on the display. • Try the function again.
“Please Wait/WAIT” appears on the display. • Wait until the message goes off.
• (If the message does not go off)
Turn Off, then turn On the power to the receiver.
“Reset 08/RESET 8” appears on the display. • Check the connection between the adapter and the
unit.
• Turn Off, then turn On the power to the receiver.
Phone sound quality is poor. • Reduce the distance between the unit and the
Bluetooth cellular phone.
• Move the car to a place where you can get a better
signal reception.
KS-BTA200_book.indb 32 KS-BTA200_book.indb 32 06.12.21 5:08:05 PM 06.12.21 5:08:05 PM