Candy LB CTA 84 AA SY - Manual (Page 3)

PREPARING THE WASH CYCLE
1.- Once the washing is loaded, ensure that the drum doors are properly closed..
2.- Add detergent and additives, not exceeding the maximum level indicator.
• detergent for pre-wash I
• detergent for wash programme II
• bleach
• fabric conditioner
SELECTING THE DESIRED PROGRAMMES AND OPTIONS
3.- Turn the programme selector (A) to the desired programme.
4.- Press the key or keys for any options desired (C1, C2, C3).
C1 easy iron key
This function helps reduce creasing, depending on the programme selected and the type
of fabric washed. This works as follows:
Synthetics. Intermediate spins during rinses are eliminated.
Delicates. Intermediate spins during rinses are eliminated and the machine stops before
the final spin, which is a gentle spin.
Woollens. Intermediate spins during rinses are eliminated and the machine stops before
the final spin.
Hand wash. The machine stops before the final spin.
Rinses. Intermediate spins during rinses are eliminated.
To complete the wash cycle in the Delicates, Hand wash, and Woollens programmes, press
the Easy Iron key again: the machine will empty and perform the required spin.
To empty machine of water with no spin, cancel the ongoing programme and select the
empty programme.
C2 extra rinse key
The electronic system engaged by this key activates a new special rinse cycle. More water
and a combination of drum rotation movements ensure that washing is perfectly rinsed.
The key can be activated in Cottons, Mixed, Synthetics, Delicates, Rinse, Woollens,
Sportswear and AA40 programmes.
C 3 super fast key
When this key is engaged programme times are cut by as much as 50 minutes, depending
on the wash programme and temperature selected. The key can be activated only in Cottons,
Synthetics and Mixed programmes.
5.- Select spin speed if required (B)
B spin selector
Use this control to select the maximum spin speed within the range for the model of washing
machine in question and the programme selected (see programme table). The control can
be turned in both directions. Spin speed may be selected at any time during the
programme.
6.- Once you have selected the desired options, press the START key (H). The washing machine
will start up and one of the time remaining or programme phase lamps (V) will come on. This
lamp indicates approximately how much time is left before the wash programme is completed
(or wash cycle phase): it will change as the programme progresses. Make sure that the stop/end
of cycle lamp is flashing before pressing the start key (H). If it remains on continuously, turn
the programme selector to OFF and re-set it to the desired programme.
To cancel an option after setting, just press the option key again (the indicator lamp will
go out).