Candy LB CTA 84 AA SY - Manual (Page 4)

07-04 / 46001778 EN
To change or cancel a programme once the programme selected has started, proceed as
follows:
- Hold down the start key (H) until the stop/end of cycle lamp is burning steadily. The
programme has been cancelled, and another may be selected.
- Select the new programme.
- Press the start key (H) again until one of the time remaining or programme phase lamps
lights up.
- The machine will then run the new programme selected.
Programme Pause
To pause the wash programme so that more washing can be added, proceed as follows:
- Hold down the start key (H) until the option key lamps begin to flash and the time remaining
or programme phase lamp lights up.
- When the Door Lock lamp goes out (after approx. 2 minutes, or 5 minutes if the machine
is equipped with the STOP & LOAD function), open the door and put the additional washing
into the drum.
- Close the drum door and the lid properly.
- Press the start key (H), the time remaining or programme phase lamp will light up and
the machine will continue with the programme.
When the programme is completed the Stop/End of cycle lamp (S) will come on and the time
remaining or programme phase and Door Lock lamps (V and G) will go out.
For your own safety, set the programme selector to OFF before opening the washing-
machine lid and the drum doors to remove the washing.