Candy PVTP 640 SN - Manual (Page 8)

8
INSTRUCTIONS FOR THE INSTALLER
IMPORTANT NOTICE
THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED PERSONNEL
EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN FORCE.
THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO PEOPLE,
ANIMALS OR THINGS, RESULTING FROM THE FAILURE TO COMPLY WITH SUCH PROVISIONS.
INSTALLATION
Installing the top
The appliance is designed to be embedded into
heat-resistant pieces of furniture.
The walls of the pieces of furniture must resist a
temperature of 65°C besides the room one.
The equipment must not be installed near
inflammable materials, such as curtains, cloths,
etc.
Make a hole in the top of the piece of furniture,
with the dimensions indicated in fig. 3, at a
distance of at least 50 mm from the appliance
border to the adjacent walls.
Any possible wall unit over the cook-top must be
placed at a distance of at least 760 mm from the
top.
It is advisable to isolate the appliance from the
piece of furniture below with a separator, leaving
a depression space of at least 10 mm (fig. 4).
If the hob is going to be installed on the top of an
oven, precautions must be taken to guarantee an
installation in accordance with current accident
prevention standards. Pay particular attention to
the position of the electric cable and gas pipe:
they must not touch any hot parts of the oven.
Moreover, if the hob is going to be installed on
the top of a built in oven without forced cooling
ventilation, proper air vents must be installed to
guarantee an adequate ventilation, with the
lower air entering with a cross section of at least
200 cm
2 , and the higher air exiting with a cross
section of at least 60 cm 2 .
Fastening the top
Ever y cook-top is equipped with a special
washer having an adhesive side.
- Remove the racks and burners from the top.
- Turn the appliance upside down and lay the
adhesive washer S along the external border of
the glass (fig. 5).
- Introduce and place the cook-top in the hole
made in the piece of furniture, then block it with
the V screws of the fastening hooks G (fig. 6).
Installation room
This appliance is not provided with a device for
ex h a u s t i n g t h e p r o d u c t s o f c o m bu s t i o n .
Therefore, it is necessary to discharge these
smokes outside.
The room where this appliance is installed must
have a natural air inflow, so as to ensure a
regular gas combustion and room ventilation: the
necessary air volume must not be lower than 20
m
3 .
Air must come from permanent openings made
on the room walls that communicate with the
outside.
The section of these openings shall correspond
to at least 200 cm
2 .
Gas connection
Make sure that the appliance is adjusted for the
gas type available (see the label under the
appliance). Follow the instructions indicated in
t h e c h a p t e r “ g a s t ra n s fo r m a t i o n s a n d
adjustments” for the possible adaptation to
different gases.
The appliance must be connected to the gas
system by means of still metal pipes or flexible
s t e e l p i p e s h av i n g c o n t i nu o u s wa l l s, i n
compliance with the regulations in force.
Some models are equipped with both cylindrical
A and conical B connectors for gas supply (fig.
7).
Please select the type which is correct for the
supply concerned.
The connection must not stress the gas ramp.
O n c e t h e i n s t a l l a t i o n i s ove r, c h e ck t h e
connection seal with a soapy solution.