Candy LB CTS 80 SY - Manual (Page 10)

10
• Water does not empty from
machine
• The washing machine is not
correctly levelled.
•
The transport “anchorage”
has not been removed.
•
The wash load is not evenly
distributed.
•
A lot of foam and water when
spinning.
• See causes for 1.
•
The tap is turned off.
• The programme selector is
incorrectly connected.
• The appliance is not plugged
in.
• The general switch is
disconnected.
•
There is no electricity.
• The fuses in the electric
installation are damaged or
blown.
•
The door is open.
• Plug it in.
• Activate the general switch.
• Check.
• Check.
• Close the door.
• Adjust the feet.
• Remove the transport
support.
• Distribute it evenly.
• Inspect and clean the filter.
• Check.
• Turn on the tap.
• Correctly connect the
programme selector.
• Check the filter.
• Straighten the hose.
•
TROUBLESHOOTING
FAULT CAUSE
1.- No programme works
SOLUTION
2.- The appliance does not
load water
3.- The water does not drain • There are foreign bodies in
the filter.
•
The outlet hose is bent.
4.- The spin programme does
not work
• The washing machine has
not yet drained the water.
•
The “Spin exclusion” option is
activated (only on some
models).
• Wait a few minutes for the
washing machine to drain.
• Deactivate the “Spin
exclusion” option.
5.- Strong vibrations during
spin cycle
• The wash load is not evenly
distributed within the drum.
• Distribute the wash load
evenly in the drum. 6.- The high-speed spin does
not work
• Contact technical service. 7.- Display will show error
nº 0, 1, 5, 7, 8, 9.
• Check that water inlet tap is
open. 8.- Display will show error nº 2 • Machine does not fill with
water
• Check that outlet is not
clogged
• Check for kinks in outlet tube. 9.- Display will show error nº 3
• Too much water in machine. • Shut off water tap.
• Contact technical service 10.- Display will show error
nº 4
IN THE FOLLOWING MODELS: ACTIVA, INTER@CT.