Candy LB CTS 80 SY - Manual (Page 7)

7
•
IMPORTANT: DO NOT TURN THE TAP ON
•
Connect the washing machine to the water mains via the
new tube supplied inside the drum. Do not use the old tube.
•
Connect one end of the water inlet pipe to the electrovalve
(top rear part of the machine) and the other to a tap or a
permanently plumbed-in _” threaded connection.
•
Position the washing machine next to the wall. Hook the
outlet pipe to the edge of the bath tub, ensuring that there
are no bends along the tube. It is better to connect the outlet
tube to a fixed outlet of a diameter greater than that of the
outlet pipe and at a height of min. 50 cm. and a maximum of
75 cm. from floor.
If necessary, use the curved accessory to attach and
support the water drainage pipe more securely.
If your model offers this function:
•
To move the washing machine easily, turn the lever to the
right. Once you have finished moving the machine, return
the lever to its original position.
•
Level the machine by adjusting the front feet.
a)Turn the nut in a clockwise direction to release the
foot’s screw adjuster.
b) Raise or lower the foot by rotating it until it stands firmly
on the floor.
c)Lock the foot in position by turning the nut in an
anticlockwise direction until it comes up against the bottom
of the machine.
Check that the appliance is properly levelled. To do so, try
and move the washing machine by pushing on two diagonally
opposite top corners at the same time to see if it rocks.
•
If you move your washing machine from one place to another,
you must level the feet again afterwards.
•
Connect the machine.