Candy CTAS 120 ES - Manual (Page 4)

DESCRIPTION OF CONTROLS
PROGRAMME/ TEMPERATURE SELECTOR ...........................
DISPLAY: Delayed start, Spin-speed, Temperature,
Time remaining ...........................................................................
SUPER FAST button ...................................................................
ACTIVA RINSE button ................................................................
EASY IRON button .....................................................................
SPIN REGULATION button ........................................................
DELAYED START button ............................................................
START/ PAUSE button ................................................................
Door secure/ door lock lamp .......................................................
Programme/ temperature table ...................................................
Marker dot ...................................................................................
A
V
D
E
F
C
I
H
G
P
p
37 38
This washing machine automatically adapts the water level to the type and quantity of clothes
to be washed. So it is possible to obtain a «customised» wash, even in terms of energy. This
system reduces water and energy consumption and provides an appreciable reduction in
wash time
PROGRAMME SELECTION
Select as follows:
• Check the programme table and set the desired programme using selector (A)
• Select the options as permitted: the options available via the keys depend on
which programme is selected. If a key flashes when pressed, the options it offers are
not available. If it remains lit, they are. Options can be seen on the display (V).
• Press the Start/ Pause button. The door lock lamp will light up and the display will
show three dashes (- - -) and then the average duration of the programme selected.
After 10-15 minutes, during which time the water temperature, amount of washing, etc.
are determined, the display will show the time remaining to the end of the wash cycle.
• Because the machine is electronic, the programme may take up to one minute to
commence. Its fuzzy logic programming technology gives this machine smart monitoring
capabilities, enabling it to adapt water levels, washing rates and spin speeds with no
further intervention by the user.
NOTE: A special memory unit stores the programme choice in case of power failure, so that
the machine will resume washing at the point where it left off when power is restored.
END OF CYCLE: At the end of the cycle the lights go out and the display reads (0 0 0). After
2 minutes, the display begins to flash. This means that the washing can be removed.
Press Start/ Pause and set the control to OFF.
CTAS 120
ACTIVE SYSTEM
The Active system owes its efficiency to its capacity to take advantage of all the force of the
water. During the washing phases the water in the drum is pumped towards an injector located
in the drum which injects a powerful water jet onto the wash. This action with an increase of
rotation speed up to 100 revolutions guarantees an optimum quality of wash and more thorough
rinsing.