Candy CTAS 120 ES - Manual (Page 5)

D
. SUPER FAST BUTTON
This function decreases programme time to a maximum of 50 minutes,
depending on the programme and wash temperature selected. The Super
Fast button can be used with loads of 1 – 4.5 kg, but only with cotton and
mixed/ synthetics programmes.
E
. ACTIVA RINSE BUTTON
This button engages a rinse function with high water levels and repeated
filling/ emptying combined with drum rotation cycles to ensure a perfect
rinse. Its use is recommended for children’s clothes or highly soiled clothing
requiring more washing powder than usual, and for fabrics whose fibres
have a tendency to retain washing products.
F
. EASY IRON BUTTON
This button works in all programmes except the cotton programme, the 32-
minute cycle and the Mix & Wash System.
This function minimises wrinkling of fabrics during wash programmes. It
works in different ways with different programmes.
In cotton programmes the machine stops on the last rinse, leaving the clothes soaking. To
spin clothes and complete the programme, press the button again to release it.
In mixed/ synthetics programmes this button cuts out the intermediate spins and runs the
final spin at low speed to minimise twisting of clothes.
In delicates, wool and hand wash programmes it stops on the last rinse, leaving the
clothes soaking. To spin clothes and complete the programme, press the button again to
release it.
To empty the machine only:
- Press Start/ Pause.
- Set the programme selector to OFF.
- Select the emptying programme .
- Wait 5 seconds.
- Press Start/ Pause.
A
. PROGRAMME/ TEMPERATURE SELECTOR
Use this control to select the desired wash programme/
temperature. Turn the control to bring the marker dot (p) into
line with the number or symbol of the desired programme.
Temperature selection depends on the programme selected.
The display shows the temperature or the relevant readings
for special programmes.
For programme selection, follow the programme table.
To change settings or programmes when a programme is
under way, proceed as follows:
- Press Start/ Pause. The display will read (0 0 0).
- Select the new programme with the selector. The temperature of the programme selected
or the relevant indication for special programmes will appear.
- Press Start/ Pause again.
- The machine will run the new programme.
To add more washing when the programme is under way, proceed as follows:
- Hold down Start/ Pause until the display shows three dashes (- - -).
- When the Door Secure lamp goes off, open the door and add more washing.
- Close the doors of the drum and the outer cover.
- Press Start/ Pause.
THIS CONTROL TURNS BOTH WAY
V
. DISPLAY: Delayed start, Spin speed, Temperature, Time remaining.
Display as per function indicated.
NOTE: Only lit buttons are enabled: if a button flashes the options it offers are not available
in the programme selected.
To change options when a programme is under way, proceed as follows:
- Press Start/ Pause until the display shows three dashes (---), then flashes the temperature
of the programme selected.
- Make the change desired (e.g. reduction of spin speed).
- Press Start/ Pause. The time remaining to the end of the programme will appear on the
display.
- The machine will resume the programme with the new setting.
39 40
USE OF THE SELECTION CONTROLS USE OF THE SELECTION CONTROLS