Candy CD 801 T - Manual (Page 8)

15
Activating and deactivating the audible signal
The audible signal function can be deactivated in the following way:
keep the “Programme Selection Button”
(P) pressed in for a few
seconds and at the same time press the stop/start button ; if the
symbol "b1" appears on the display the audible signal is activated.
Press the “Programme Selection Button”
(P) again and the symbol
"b0" will appear which means that the audible signal has been
deactivated.
An audible signal sounds to indicate that the setting has been stored in
memory.
Pr
Pr
I
14
Interrupting a programme
It is not recommended that the door be opened while a programme is
running, and especially not during the main wash phase and final drying.
However, the appliance will stop automatically when the door is opened.
At this point the various wash options can be programmed or cancelled.
The current programme can also be cancelled.
If, the door is opened during a programme, the symbol for that programme
will flash in the display and the machine stops.
Please Note:
If you open the door during the drying cycle an audible audio signal
advises you that the drying cycle has not yet completed.
To restart the machine, press the "START" button and the time remaining
for the programme will flash. Now close the door.
If you wish to cancel or change a programme that is running, carry
out the following:
keep the "START" button pressed in until the number of the
programme stops flashing. A new programme can now be set.
NB: If, on pressing the "START" button the symbol "00" starts to flash on
the display, it means that there is water in the machine.
Then release the "START" button and the machine will automatically
empty the water; wait for the audible signal, after which the new
programme can be set.
Before starting a new programme, you should check that there is still
detergent in the dispenser. If necessary, top up the dispenser.
End of programme
The end of the programme is indicated by an audible signal (if it has not
been deactivated). The number of the programme that has just finished will
appear on the display.
Important:
If the programme shown in the display starts to flash and the machine
will not let any more programmes be selected, press the ''START''
button and keep this button pressed until the display stops flashing.
Delay Start programme button
To set the delay start programme press the button.
On the first press the current setting appears on the display. Each time the
button is pressed the delayed time in one hour increments increases, up
to a maximum of 19 hours.
Once set, wait until the selected time is confirmed when it appears in the
display. Press the "START" button to start the countdown. If the
countdown has not already been activated, the delay start can be
cancelled by pressing the button until the selected programme
appears on the display.
The delay start can be cancelled at any time simply by keeping the
"START" button pressed in until the required wash cycle appears on the
display.
If you wish to see which programme has been selected, press the
"Programme Selection Button” .
NB: If the door is opened during the countdown, for example to select one
of the options (or to add more dishes), the "START" button should be
pressed before closing the door again, in order to restart the countdown.
Pr
Display shows E1.
Display shows E2.
Display shows E3.
Display shows E4.
Display shows E5.
PROBLEM CAUSE REMEDY
The Dishwasher is able to self-assess a number of problems. The problem will
be illustrated in the display window and by an audible signal.
Water supply switched off.
Problem with electronic temperature
control.
The Water Heater Element does not
work properly or the filter mesh is
blocked.
The appliance does not discharge
water.
Problem with electronic load device.
Switch off appliance.
Turn on water supply.
Reset the cycle.
Call Service for assistance.
Clean the Filter Mesh and if the
problem continues please contact
Service.
Check :
• That the discharge hose is not
bent
• Syphon is not blocked
• Filters are not blocked
Call Service for assistance.
PROBLEMS AUTOMATICALLY SIGNED