Instructions for the installer, Electrical connection, Gas connection – Candy PLC 2230 X User Manual

Page 27

Advertising
background image

26

Instructions for the installer

The following information is intended for qualified and competant persons only who will
ensure that your appliance is installed correctly. All current legislation concerning the
installation of Gas appliances must be observed by the installer*

* For the U.K. only - By law, the gas installation/commissioning must be carried out
by a «Corgi», registered installer.
This appliance must be installed in accordance with applicable regulations and should
only be used in well-ventilated locations. Before using this appliance carefully study the
instruction book.

Electrical connection

Warning - this appliance must be earthed
This appliance is designed for domestic use only. Connection to the mains supply must
be made by a competant electrician, ensuring that all current regulations concerning
such installations are observed.
The appliance must only be connected to a suitably rated spur point, a 3 pin 13 amp
plug/socket is not suitable. A double pole switch must be provided and the circuit must
have appropriate fuse protection. Further details of the power requirement of the in-
dividual product will be found in the users’ instruction and on the appliance rating plate.
In the case of built-in product you are advised, should you wish to use a longer cable
than the one supplied, that a suitably rated heat resistant type must be used.
The wiring must be connected to the mains supply as follows:

CONNECT

TO SPUR TERMINAL

Green & Yellow

Wire Earth Connection

Blue Wire

Neutral Connection

Brown Wire

Live Connection

Note: We do not advocate the use of earth leakage devices with electric cooking ap-
pliances installed to spur points because of the «nuisance tripping» which may occur.
You are again reminded that the appliance must be correctly earthed, the manu-
facturer declines any responsibility for any event occurring as a result of incorrect
electrical installation.

Declaration of compliance: This equipment, in the parts intended to come into con-
tact with food, complies with the regulations laid down in EEC directives 89/109.

This appliance complies with directive 89/336/EEC, 73/23/EEC, 90/396/EEC and
the following changes.

Gas connection

(see page 33)

The labels on the Hob indicate the types of gas that can be used.
It is possible to use other types of gas after carrying out simple modifications.
Warning: If gas can be smelt in the vicinity of this appliance turn off the gas supply to
the appliance and call the engineer directly.
Do not search for a leak with a naked flame.

Advertising