Use of hob, User instructions – Candy PLC 2230 X User Manual

Page 30

Advertising
background image

29

ATTENTION: When cleaning the hob, take care to replace the burners correctly,
this will ensure that the ignition point is not blocked.

GENERAL ADVICE
For the best results, the flat-bottomed pans size should match the gas burner size as
follows:
— Front right burner

from 6 to 12 cm.

— Front left burner

from 24 to 26 cm.

— Back left burner

from 12 to 18 cm.

— Back right burner

from 18 to 24 cm.

See fig. 1b pag. 23.

For smaller containers the gas burner should be regulated so that the flame does not
overlap the base of the pan. Vessels with concave or convex base should not be used.
WARNING: If a burner is accidentally extinguehed, turn the knob to the off posi-
tion and do not attempt to re-ignite if for at least 1 minute.
To protect the glass lid from damage and in the interests of safety, the burners/plates
must be turned off and the burner/pan support/plate area must be cool before closing
the lid down.

Use of electric hotplates (electric hotplates)

For the best use of the electric hotplates and to minimise energy consumption, the fol-
lowing recommendations should be noted.

USE OF HOB

User instructions

This appliance must only be used for the purpose for which it is intended, domestic
cooking, and any other use will be considered improper and could therefore be danger-
ous. The Manufacturer will not be responisble for any damage or loss resulting from
improper use.

Using the gas Burner

To ignite the burners, place a lighted taper close to the burner, press in and turn the
control knob anti-clockwise.
If the burners have not been used for a couple of days, wait for a few seconds before
lighting the burner, this will allow any air present in the pipes to escape.
For appliances fitted with electronic ignition carry out the following:
• push in and turn the knob anticlockwise to the

symbol.

• ignite the burner by pressing the sparker button.
For hobs fitted with automatic ignition simply push in and turn the knob to the

sym-

bol.
The ignition generator is a repetitive discharge type.
If the burner is not ignited within 5 seconds, turn the knob to the 0 position and repeat
the operation.
For models fitted with a safety tap (which cuts-off the flow of gas if the flame is acci-
dentally extinguished) the burners are ignited ad described above, but care must be
taken to keep the knob pressed in for 5 or 6 seconds after the flame is ignited.

Advertising