Candy LTO 106 A SYMBOL - Manual (Page 4)

USE OF THE SELECTION CONTROLS
A
. PROGRAMME SELECTOR KNOB
To select the desired wash programme, turn this control until
the line (L) coincides with the programme number or symbol.
ALWAYS ROTATE the control in a clockwise direction, never
in an anticlockwise direction. Do not press the “on” button
(H) before selecting the programme.
If you wish to modify the position of the control or select
another programme once a cycle has commenced, press
the Start/Stop key. Press again to recommence once the
modification has been completed.
f
. PROGRAMME STAGE DISPLAY
This displays the current programme stage throughout the programme selected.
WASH: STOP WITH WATER IN DRUM:
RINSE: END OF PROGRAMME:
FINAL SPIN:
t
. TIME REMAINING DISPLAY
This displays the Approx. time remaining in minutes to the end of the
programme.
B
. TEMPERATURE SELECTOR KNOB
To select the desired wash temperature, turn this control until
the line (L) coincides with the desired temperature.
If you wish to carry out a cold wash, turn the knob until the
cold symbol coincides with the selector mark.
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
Do not exceed the maximum temperature recommended for
each cycle in the table of programmes.
42 43
CONTROL DESCRIPTION
PROGRAMME SELECTOR KNOB ............................................
- PROGRAMME STAGE DISPLAY .................................
- TIME REMAINING DISPLAY ........................................
TEMPERATURE SELECTOR KNOB .........................................
SPIN SPEED SELECTOR KNOB ...............................................
DELICATE WASH BUTTON .......................................................
FLOT BUTTON (ANTICREASING) ............................................
ON/OFF PILOT LIGHT ...............................................................
ON/OFF BUTTON ......................................................................
SELECTOR MARK .....................................................................
A
f
t
B
C
D
E
G
H
L
LTO 86 B LTO 86 B