Candy LTO 106 A SYMBOL - Manual (Page 6)

USE OF THE SELECTION CONTROLS
A
. PROGRAMME SELECTOR KNOB
To select the desired wash programme, turn this control until
the line (L) coincides with the programme number or symbol.
ALWAYS ROTATE the control in a clockwise direction, never
in an anticlockwise direction. Do not press the “on” button
(H) before selecting the programme.
If you wish to modify the position of the control or select
another programme once a cycle has commenced, press
the Start/Stop key. Press again to recommence once the
modification has been completed.
f
. PROGRAMME STAGE DISPLAY
This displays the current programme stage throughout the programme selected.
WASH: STOP WITH WATER IN DRUM:
RINSE: END OF PROGRAMME:
FINAL SPIN:
t
. TIME REMAINING DISPLAY
This displays the Approx. time remaining in minutes to the end of the
programme.
B
. TEMPERATURE SELECTOR KNOB
To select the desired wash temperature, turn this control until
the line (L) coincides with the desired temperature.
If you wish to carry out a cold wash, turn the knob until the
cold symbol coincides with the selector mark.
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
Do not exceed the maximum temperature recommended for
each cycle in the table of programmes.
USE OF THE SELECTION CONTROLS
C
. SPIN SPEED SELECTOR KNOB
To select the final spin speed, turn this control until the line
(L) coincides with the desired rpm.
This knob selects the final spin speed. To select a speed,
press down and turn until the desired speed coincides with
the selector mark.
The final spin cycle reaches the maximum speed selected in
non-delicate programmes. The middle and final spin cycles
for mixed, synthetics and delicate programmes is carried out
at 400 r.p.m.
If you do not want a spin cycle, coincide the spin exclusion
symbol with the selector mark.
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
D
. SUPER-RINSE BUTTON
Pressing this button removes the last vestiges of soap powder from the
fabrics, as the rinses are done with more water. Programmes 1-2-3-4.
E
. DELICATE WASH BUTTON
Pressing this button varies the number of turns of the drum in the pre-wash,
wash and rinse phases (programmes 9-10). This allows an extra-delicate wash,
especially suitable for wool and very delicate fabrics. Also indicated for mixed
fabrics, clothes only lightly soiled, and non-iron garments.
F
. FLOT BUTTON (Anticreasing)
The Flot button only works in programmes (5-6-7-8-9-10) for mixed, synthetic
and very delicate fabrics.
When the button is pressed, the machine stops in the last rinse of these
programmes, leaving the wash soaking with a high water level.
To complete these programmes, spin the wash by pressing the button again to
release it.
G
. ON/OFF PILOT LIGHT
H
. ON/OFF BUTTON
46 47
LTO 106 A
LTO 126 A LTO 106 A
LTO 126 A