Remington EP7020 - Manual (Page 6)

6
ENGLISH
A CAUTION
• For your protection your epilator may slow down or even stop if pressed too firmly
against the skin.
• Do not use the epilating head on irritated skin or skin with varicose veins, rashes, spots,
moles or wounds without consulting a doctor. People with reduced immune response
e.g. during pregnancy, or people who suffer from diabetes mellitus, haemophilia or
immunodeficiency should also consult their doctor before using this product.
• For hygiene reasons do not let another person use your epilator. It is recommended for
use by one person only.
C CLEANING AND MAINTENANCE
To ensure long lasting performance of your epilator, clean the head assembly regularly.
Cleaning the epilation head after each use:
• Ensure the epilator is turned off and disconnected from the mains.
• Press the head release button and open the head assembly. (Diagram F)
• Turn the head assembly upside down.
• The epilator head can be removed and rinsed for cleaning. For optimal cleaning; brush
hairs from the tweezers before rinsing. (Diagram G)
• Although the epilator is suitable for use under running water, it is not recommended to
submerge the unit under water.
NOTE: Do not completely submerge in water. The epilator head can be submerged after it has
been removed from the epilator body.
To remove residue
• To remove residue from the stainless steel tweezers, dampen a swab with alcohol.
• Gently run the swab over the tweezers until the residue has been removed.
CAUTION: Make sure that the cotton swab is not soaked in alcohol as this may damage the
epilator.
Cleaning the Shaver Head after each use:
• Ensure the epilator is turned off and disconnected from the mains.
• Press the head release button and remove the shaving head.
• Remove the blade and trimmer assembly by placing your fingers either side of the
assembly and pulling upwards.
• Gently shake the blade and trimmer assembly to remove the hair. Use the cleaning
brush to brush the trimmers and shaver housing.
• Replace the blade and trimmer assembly.
NOTE: Never use the cleaning brush on the foil as damage may occur.