Remington R3150 - Manual (Page 9)

3
ENGLISH
CLEANING DAILy
Ensure the shaver is switched off and unplugged from the mains.
Open the shaver head by pressing the release button on the front of the shaver (Fig. H).
Tape out excess hair shavings (Fig. I).
Close head assembly (Fig. J).
CLEANING MONTHLy
CAUTION:
Never submerge your shaver in water.
CLEANING TRIMMER
Lubricate the teeth of the trimmer every six months with one drop of sewing machine oil.
IMPORTANT SAfETy INSTRUCTIONS
WARNING – TO REDUCE THE RISK Of bURNS, ELECTROCUTION, fIRE,
OR INJURy TO PERSONS:
An appliance should never be left unattended when plugged in to a power outlet, except
when charging.
Keep the power plug and cord away from heated surfaces.
Make sure the power plug and cord do not get wet.
Do not plug or unplug the shaver with wet hands.
Do not use the product with a damaged cord. A replacement can be obtained via the
Remington ® Service Center.
use and store the product at a temperature between 0°C and 32°C.
Only use the parts supplied with this appliance. Use of non Remington ® parts with this
product may give rise to a hazardous condition.
Do not submerge or place under running water.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge can
give cause to hazards. Persons responsible for their safety should give explicit instructions
or supervise the use of the appliance.
GB
D
NL
F
E
I
DK
S
FI
N
P
SK
CZ
PL
H
UN
RU
TR
RO
GR
SL
AE
HR/ SRB
GB
090250_REM_IFU_R3130_22L.indd 3 14:58:15|01.05.09 Guido Krölls
Perform the daily cleaning steps first
Open the shaver head by pressing the release button on the front of the shaver (Fig. I) and
flipping open the head away from the body of the shaver (Fig. J).
Release the inner cutter carrier by rotating the locking arms counter-clockwise (Fig. M).
Pull the inner cutter carrier away from inner cutters (Fig. N).
Thoroughly brush hairs from the inner and outer cutters (Fig. P) and rinse out remaining
debris.
Replace inner cutter (Fig. O)
Place the inner cutter carrier back onto the upper hairpocket and lock in place by rotating
the locking arms clockwise until the arms ´click`into playe (Fig. Q-R).
Replacement Part No. SP-SFD2