Remington IPL6000F - Manual (Page 14)

14
ENGLISH
C
CLEANING YOUR i-LIGHT DEVICE
F CAUTION: Before cleaning your i-Light, make sure that the power switch is OFF and the
power cord is disconnected from the base unit.
• Regular cleaning helps to ensure optimal results and a long life for the i-Light device. The exterior surface
of the base unit and hand piece may be wiped clean with a slightly damp cloth.
• To clean the Flash Window, use only the lint-free cloth included with your i-Light device. Take care not to
scratch or chip the Flash Window. Scratches and chips can reduce the effectiveness of the unit.
• For stubborn stains, use a dampened cotton swab to apply a small amount of water to the Flash Window
and clean with the lint-free cloth provided.
• Use a small hand-held vacuum to remove dust and debris from the hand piece vents.
F
WARNING: If the Flash Window is cracked or broken, the unit must not be used. Never scratch the filter
glass or the metallic surface inside the Treatment Head.
F CAUTION: The i-Light is a high voltage device. Never immerse in water. Never clean the unit or any of its
parts under a tap or in a dishwasher. Do not use petroleum-based or flammable cleaning agents because of
the risk of fire. Never use scouring pads, abrasive cleaning agents or aggressive liquids such as oil or acetone
to clean the unit.
E
TROUBLESHOOTING / STORAGE / MAINTENANCE
, i-Light Device Maintenance
F CAUTION: Before performing maintenance on your i-Light device, ensure that the power switch is OFF
and the power cord is disconnected from the base unit.
, Replacing the Bulb
1. Press the treatment head release buttons and gently pull to remove the treatment head.
2. Gently pull out the old bulb cartridge.
3. Replace with a new bulb cartridge.
F CAUTION: When replacing the bulb cartridge, do not touch the flash bulbs directly as this leaves oils and
residue. Doing so could reduce the effectiveness of the bulbs or cause them to crack during treatment.
4. Replace the treatment head, making sure it snaps into place.
, Storage
• Switch off the unit, unplug it and let it cool down for 10 minutes before storage.
• Store the unit in a dry place at a temperature between 15º C and 35º C.
, Troubleshooting
Always read these instructions fully before using i-Light. Refer to this troubleshooting guide if you
experience any problems with i-Light, as this section addresses the most common problems you could
encounter with i-Light. If you have followed the instructions in this section and continue to experience
problems, please contact the Remington® Service Centre for further assistance.